Sony XM1505SX, XM1805GX free download

File name Sony-XM1505SX_1805GX caramp.pdf

XM-1505SX/1805GX SERVICE MANUAL Ver 1.1 2001.06 US Model Canadian Model XM-1505SX/1805GX E Model XM-1505SX Photo: XM-1805GX SPECIFICATIONS AUDIO POWER SPECIFICATIONS POWER OUTPUT AND TOTAL HARMONIC DISTORTION 40 watts/150 watts per channel minimum continuous average power into 4 ohms, 5channels driven from 50 Hz (1505SX), 20 Hz (1805GX) to 20 kHz/20 Hz to 300 Hz (subwoofer) with no more than 0.04% total harmonic distortion per Car Audio Ad Hoc Committee standards. Other Specifications OTL (output transformerless) circuit Pulse power supply Inputs RCA pin jacks Outputs Speaker terminals Through out pin jacks Speaker impedance 2 ­ 8 (stereo) 4 ­ 8 (when used as a bridging amplifier) 1.3 ­ 8 (only for subwoofer output) (XM-1805GX) Maximum outputs 80 watts Ч 4 + 300 watts Ч 1 (at 4 ) Rated outputs (supply voltage at 14.4 V) 5 Speakers: 1505SX: 40 watts Ч 4 (50 Hz ­ 20 kHz, 0.04% THD, at 4 ) + 150 watts Ч 1 (20 ­ 300 Hz, 0.04% THD, at 4 ) 60 watts Ч 4 (50 Hz ­ 20 kHz, 0.1% THD, at 2 ) + 180 watts Ч 1 (20 ­ 300 Hz, 0.1% THD, at 2 ) 1805GX: 40 watts Ч 4 (Front: 50 Hz ­ 20 kHz, Rear: 20 Hz ­ 20 kHz, 0.04% THD, at 4 ) + 150 watts Ч 1 (20 ­ 300 Hz, 0.04% THD, at 4 ) 60 watts Ч 4 (Front: 50 Hz ­ 20 kHz, Rear: 20 Hz ­ 20 kHz, 0.1% THD, at 2 ) + 180 watts Ч 1 (20 ­ 300 Hz, 0.1% THD, at 2 ) 3 Speakers: 120 watts Ч 2 (50 Hz ­ 20 kHz, 0.1% THD, at 4 ) + 150 watts Ч 1 (20 ­ 300 Hz, 0.04% THD, at 4 ) Circuit system Frequency response 5 Hz ­ 50 kHz ( +0 dB) ­3 Harmonic distortion 0.005% or less (at 1 kHz, 4 ) Input level adjustment range 0.2 ­ 6.0 V (RCA pin jacks) High-pass filter 50 ­ 300 Hz, ­12 dB/oct Low-pass filter 50 ­ 300 Hz, ­12 dB/oct Phase shift adjustment range (XM-1805GX) 0° ­ 180° (at 40 Hz) (only for subwoofer output) Power requirements 12 V DC car battery (negative ground) Power supply voltage 10.5 ­ 16 V Current drain at rated output : 42 A Remote input : 1.0 mA Dimensions Approx. 358 Ч 50 Ч 264 mm (w/h/d) (14 1/8 Ч 2 1/4 Ч 10 1/2 in.) not incl. projecting parts and controls Mass Approx. 3.5 kg (7 lb. 11 oz.) not incl. accessories Supplied accessories Mounting screws (4) Design and specifications are subject to change without notice. STEREO POWER AMPLIFIER 9-870-240-12 2001F0400-1 © 2001.6 Sony Corporation e Vehicle Company Shinagawa Tec Service Manual Production Group 1 SECTION 1 SERVICE NOTE TABLE OF CONTENTS 1. SERVICE NOTE ... 2 2. GENERAL Location and Function of Controls ... 3 Connections ... 4 heat sink (retainer plate) C937 Q512 Q510 NOTE FOR REPLACEMENT OF Q510 AND Q512 When replacing Q510 and Q512, remove C937 and then remove the screw securing the heat sink (retainer plate). 3. DISASSEMBLY 3-1. 3-2. 3-3. 3-4. Plate, Bottom ... 6 Amp Board Section ...